多环芳烃的几种理化参数与LC_(50)的相关性研究

对多环芳烃(PAHS)4种理化参数(K;W、Sw。X Vv。)与 LCO的相关关系进行了研究,建立了 4种一元线性回归方程。结果表明,4种参数的相关系数分别为:0.刀66、08083、09488、0.9570,经r检验,后两种属高度显著相关.用所建立的一元线性回归方程对7种PAHS的LC。进行估算,估算值与实测值相比,平均相对误差分别为58.84％、32.23％、1761％、198％,用l和V＊.H对LClj进行估算的估算精度也较高。经比较,提出用(。估算P＊比对麦穗鱼＊CO的新方法。     

活性炭吸附与生物活性炭脱臭效果的比较研究

针对污水收集与处理系统中恶臭气体的组成与特性,比较分析不同情况下活性炭吸附与生物活性炭的脱臭效果。当干活性碳总处理气量达到1.3m~3/g时,出现穿透。将吸附饱和的活性炭填料塔转为生物滴滤反应器后,仍能较快的实现挂膜生长,达到满意的处理效果。直接运行的生物活性炭滴滤器对H_2S的处理效率在95％以上,并具有较强的恢复能力。H_2S平均出口浓度为0.052mg/m~3。循环液pH值与盐度在一定范围内对系统影响不大。     

硝基苯废水治理技术研究进展

综述了近年来硝基苯废水治理方法的研究进展．介绍了物理法、化学法和生物法在治理硝基苯废水中的不同作用，指出物化法与生物法相结合会成为根治硝基苯废水的理想方法。     

中国煤矿工人体能负荷、疲劳与工伤事故

煤矿井下事故对矿工威胁很大，体力负荷过重而导致疲劳是引起事故不可忽视的原因。测定不同工种井下矿工的体能负荷情况，并根据ＦＩＸ疲劳指数的测定，分析矿工劳动负荷与工伤事故发生之间的关系。研究表明，在疲劳状态下事故发生的危险性增加；劳动负荷越重，疲劳越重相对的事故发生率也越高。减轻疲劳对预防事故发生与保证工作安全具有很重要的意义     

Locally enhanced electric field treatment (LEEFT) for water disinfection

• Nanowire-assisted LEEFT is applied for water disinfection with low voltages. • LEEFT inactivates bacteria by disrupting cell membrane through electroporation. • Multiple electrodes and device configurations have been developed for LEEFT. • The LEEFT is low-cost, highly efficient, and produces no DBPs. • The LEEFT can potentially be applicable for water disinfection at all scales. Water disinfection is a critical step in water and wastewater treatment. The most widely used chlorination suffers from the formation of carcinogenic disinfection by-products (DBPs) while alternative methods (e.g., UV, O₃, and membrane filtration) are limited by microbial regrowth, no residual disinfectant, and high operation cost. Here, a nanowire-enabled disinfection method, locally enhanced electric field treatment (LEEFT), is introduced with advantages of no chemical addition, no DBP formation, low energy consumption, and efficient microbial inactivation. Attributed to the lightning rod effect, the electric field near the tip area of the nanowires on the electrode is significantly enhanced to inactivate microbes, even though a small external voltage (usually<5 V) is applied. In this review, after emphasizing the significance of water disinfection, the theory of the LEEFT is explained. Subsequently, the recent development of the LEEFT technology on electrode materials and device configurations are summarized. The disinfection performance is analyzed, with respect to the operating parameters, universality against different microorganisms, electrode durability, and energy consumption. The studies on the inactivation mechanisms during the LEEFT are also reviewed. Lastly, the challenges and future research of LEEFT disinfection are discussed.     

铁路职工健康维护工作初探

从健康意识逐渐提高、健康知识不断增加、健康生活方式逐步建立及健康状况有所改善等方面阐述铁路实施健康行动计划后取得的成效,分析健康维护中存在的主要问题,即专业人员不足、服务方式较单一及高血压控制率有待提高,进而提出加强专业队伍建设、引进研发新设备、强化铁路健康教育及深化“四高”联防联控等进一步开展健康维护工作的建议。     

Evaluation of a recycling process for printed circuit board by physical separation and heat treatment

Printed circuit boards (PCBs) from discarded personal computer (PC) and hard disk drive were crushed by explosion in water or mechanical comminution in order to disintegrate the attached parts. More parts were stripped from PCB of PC, composed of epoxy resin; than from PCB of household appliance, composed of phenol resin.In an attempt to raise the copper grade of PCB by removing other components, a carbonization treatment was investigated. The crushed PCB without surface-mounted parts was carbonized under a nitrogen atmosphere at 873–1073 K. After screening, the char was classified by size into oversized pieces, undersized pieces and powder. The copper foil and glass fiber pieces were liberated and collected in undersized fraction. The copper foil was liberated easily from glass fiber by stamping treatment.As one of the mounted parts, the multi-layered ceramic capacitors (MLCCs), which contain nickel, were carbonized at 873 K. The magnetic separation is carried out at a lower magnetic field strength of 0.1 T and then at 0.8 T. In the +0.5 mm size fraction the nickel grade in magnetic product was increased from 0.16% to 6.7% and the nickel recovery is 74%.The other useful mounted parts are tantalum capacitors. The tantalum capacitors were collected from mounted parts. The tantalum-sintered bodies were separated from molded resins by heat treatment at 723–773 K in air atmosphere and screening of 0.5 mm. Silica was removed and 70% of tantalum grade was obtained after more than 823 K heating and separation.Next, the evaluation of Cu recycling in PCB is estimated. Energy consumption of new process increased and the treatment cost becomes 3 times higher comparing the conventional process, while the environmental burden of new process decreased comparing conventional process.The nickel recovery process in fine ground particles increased energy and energy cost comparing those of the conventional process. However, the environmental burden decreased than the conventional one.The process for recovering tantalum used more heat for the treatment and therefore the energy consumption increased by 50%, when comparing with conventional process. However, the market price for tantalum is very large; the profit for tantalum recovery is added. Also the environmental burden decreased by the recycling of tantalum recovery. Therefore, the tantalum recovery is very important step in the PCB recycling. If there is no tantalum, the consumed energy and treatment cost increase in the new process, though the environmental burden decreases.     

氯灭活地下水源中3种优势真菌的效能与机制

地下水源中真菌大量繁殖会产生嗅味,引发毒性反应以及产生大量肉眼可见的絮状物,严重影响供水水质.以地下水源中3种优势真菌木霉属、青霉属、枝孢属为研究对象,以氯为消毒剂,通过研究真菌孢子胞内物质泄漏,胞外三磷酸腺苷(ATP),脱氧核糖核酸(DNA)和蛋白质增加及孢子形态变化,探明了氯灭活3种真菌孢子的效能与机制.结果表明,氯灭活真菌孢子符合一级动力学,满足Chick模型,3种真菌的耐氯性为:木霉属青霉属枝孢属,真菌孢子尺寸越大,亲水性越强,灭活效果越好.氯灭活后,胞内物质泄漏,胞外特征物质(ATP、DNA、蛋白质)显著增加;氯对细胞表面破坏严重,灭活后真菌孢子凹陷,表面褶皱.综上所述,氯首先作用于孢子表面,降低孢子的可培养性,进一步作用使细胞的通透性屏障受损,导致胞内特征物质释放,以致孢子死亡.     

UV和H2 O2联合消毒灭活饮用水中大肠杆菌研究

以大肠杆菌为研究对象,对单独紫外线(UV)、H2O2及两者不同组合方式的灭活效果进行了分析.结果表明,单独H2O2对大肠杆菌基本无灭活效果,加入浓度为20 mg·L-1的H2O2接触时间为30 min时,灭活率仅为0.02个对数级;单独UV工艺可在一定程度上灭活大肠杆菌,紫外线剂量为10 mJ·cm-2时,灭活率可达到4.51个对数级.紫外线和H2O2联合消毒在一定程度上提高了消毒效果,且不同的组合方式对灭活效果有很大的影响.先UV后H2O2消毒效果优于先H2O2后UV,当紫外线剂量为5 mJ·cm-2时,加入H2O2分别反应2.5、5、10、20 min后,两者的灭活率分别较单独UV消毒增加0.09、0.35、0.38、0.68和0.01、0.07、0.14、0.53个对数级.而UV与H2O2同时消毒效果优于UV与H2O2顺序消毒,当紫外线剂量为5 mJ·cm-2时,加入H2O2反应20 min后,灭活率较UV-H2O2和H2O2-UV工艺分别增加了0.43和0.58个对数级.随着紫外线强度的增加,大肠杆菌的灭活效果不断提高.     

染料废水处理技术现状与发展

介绍了染料废水的物理、化学和生物处理技术,分析了其去除原理和工艺优缺点,提出了未来染料废水处理技术的发展走向——高效、经济、适应性强、清洁性的废水处理技术。